High voltage amplifier

Ultra low noise high voltage amplifier

New: WMA-200 ultra-low noise high voltage amplifier
With this amplifier, you get the lowest noise high voltage amplifier in the industry

High voltage amplifier special offer

Check out our special offer
10% off on the all-round WMA-100 high voltage amplifier

High voltage amplifier accessories

Cables and connectors for high voltage amplifiers

WMA-005 Low voltage DC / battery powered high voltage amplifier

The Falco Systems WMA-005 is a high voltage amplifier that runs from an 24 - 30V DC power supply and can be battery powered if required, e.g. for use in a Faraday cage. Its internal high voltage generator is inductor-free and hence does not spread magnetic interference in sensitive experimental setups. The output noise is impressively low at 3mVrms. For extremely low noise applications where bandwidth is not an issue, a dedicated WMA-005LF version is available that contains an output low pass filter capacitor which reduces the bandwidth to 50Hz, but makes the noise drop to below 0.1mVrms. This bandwidth-limited amplifier is ideal for MEMS or piezo positioning with manual voltage adjustment.
Battery powered high voltage amplifier for MEMS
- High voltage 20x amplification up to +75V and -75V with respect to ground
- DC to 20kHz full-power bandwidth (-3dB) WMA-005
- DC to 50Hz full-power bandwidth (-3dB) WMA-005LF
- Low output noise: <3mVrms for the WMA-005 and <0.1mVrms for the WMA-005LF typical
- Continuous short-circuit protection
- No overshoot with capacitive loads and perfectly stable
- 100kOhm input impedance
- 50kOhm output impedance
- 50x100x26mm size
- 24V - 30V single DC power supply, 120mA

The WMA-005 high voltage amplifier is priced at EUR 395.- (EU price)
Please ask for our educational and quantity discounts

Typically ships within a few weeks

High voltage amplifier WMA-005 - download flyer

High voltage amplifier WMA-005 - download user manual